Renfro Valley Dual Sport – 2017 Edition
Hat’s off to the organizer’s of the 2017 Renfro Valley Dual Sport once again! I’ve only done this three years now, and each time, I’ve been amazed at how well they mark the route. If you pay...
May 12, 2017
Hat’s off to the organizer’s of the 2017 Renfro Valley Dual Sport once again! I’ve only done this three years now, and each time, I’ve been amazed at how well they mark the route. If you pay...
It was about this time last year when we decided to get either a 3/4-ton Diesel truck or a Sprinter. I didn’t know much about them then, but by September we were test driving one...
June 12, 2016
Lately, work has been slow on the Sprinter. But as we’ve geared up for our annual westward pilgrimage, I’ve been prompted to make some additional improvements that are going to be handy while traveling....
May 2, 2016
I’d heard about this event for many years, but honestly, I didn’t have a good idea of what it was all about. I mean, it is called a “dual sport” how much fun can that be?...
New Tires: Originally, the van had 245/75 R16 Continental VancoFourSeason tires gracing the silver steel rims. It rode very well on the highway and there was minimal road noise. No complaints at all in that regard....
Nerf Bars: I spent weeks looking at running boards and nerf bar options for the NCV3 Sprinter. There were abundant options for “generic” running boards. Many looked like they “kinda” fit and one person...
Work on the Sprinter has been progressing but now at a slower pace. I figure that the end of “Phase 1” is near as much of my time has been spent tying up loose...
Fender Well Box: I found several references to fender well boxes or covers on the Sprinter-Source forum. After noting how my motorcycle tie downs were routed it appeared that I could have one, but...
When I was young, we’d ride each time it snowed. Sometimes it was just on a small plot of land next to our house, but we’d ride. I can remember my Father, my Uncle...
Partition: The C-pillar partition is nearly complete. Olympic deck coating was used to cover both the main panel and the door. There are a total of 3 coats on each side but none on the edges. I...